Conair S900II System Technické informace stáhnout pdf (Strana 70)

Programming S900–II Level 1

Version 2.2 |–>

V – Specific programming

01T01527_2

25.5.00

V – 5. 1. Anticipated restart with programmed delay (Parameter 174 = 2)

For the anticipated restart with programmed delay to be effective, step 00 of the program used must

contain the instruction SET WWRD 63 = xxxx where xxxx is the length in 1/10 s. of the delay that

you wish to apply between :

 the decoding of the instruction “machine cycle validation” (VCM),

and

 the activation of the mould closing authorization commands.

Reminder

: xxxx must also 

Parameter 175

To optimize the anticipation, it is possible to change the length of the delay (value xxxx of WWRD63)

in automatic mode.

Change Machine delayed start : 0500 ms

Enter value + ENTER

MAINT | HISTO | PRODUC | |MONIT

Enter the new value

using the alphanumeric

keys and confirm by

pressing

End of modification

V – 5. 2. Auto–adaptative anticipated restart (Parameter 174 = 1)

In this case, the robot calculates by itself the delay applied between the decoding of the “machine cycle

validation” instruction (VCM) and the activation of the mould closing authorization commands.

The value of the minimum delay that can be applied is in parameter 176. Each time the robot (

V 2.2

or the IMM) stops, the delay applied takes the value of parameter 175 again. The calculation is made

by successive tries. It will be optimal after several cycles in automatic mode. It is not necessary to put

the instruction SET WWRD 63 in the program.

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 81 82

Žádné komentáře

Conair S900II System Technické informace Strana 70