Conair FC-33 Uživatelská příručka stáhnout pdf (Strana 22)

CF Series Granulators UGG003/0398

18 SERVICE

7.3 Transmission

Vee belts, inspection and adjustment

The granulator is driven by 3 V-belts.

Checking the V-belts

The tension and condition of the V-belts must be checked after 20 - 30 hours

of operation at full load.

After this, check the V-belts for damage once a month.

Check the belt tension every 6 months.

¥ Undo and remove the upper panel on the right-hand side of the granulator.

¥ Rotate the V-belts a few turns.

Check that the belts are intact, undamaged and uncracked.

WARNING! Pinch risk between pulleys and V-belts.

¥ Check belt tension and adjust if necessary.

Motors up to 7.5 kW:

¥ Load each one of the belts in turn with 20 N,

centrally between the cutter and belt pulleys.

It should not be possible to depress the belt more

than about 5 mm.

11 kW motor:

¥ Load each one of the belts in turn with 27 N, centrally between the

cutter and belt pulleys.

It should not be possible to depress the belt more than about 5 mm.

V-belt adjustment

¥ Remove the upper panel on the right-hand side of the granulator.

¥ CF series-K, remove the rear guard plate

above the motor and open the door.

¥ Undo and remove the extraction pipe.

Alt. CF series-U, undo the quick coupling

on the outlet pipe stub.

Motors up to 7,5 kW

L = 5 mm; F = 20 N

11 kW motor

L = 5 mm; F = 27 N

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 57 58

Žádné komentáře

Conair FC-33 Uživatelská příručka Strana 22