Conair Hopper Temperature Controller UGD031 Uživatelský manuál stáhnout pdf (Strana 95)

Addendum l AD-13

Blower Troubleshooting (continued)

Problem

Overheated bearings.

Possible cause

Too much grease.

Damaged wheel or driver.

Bent shaft.

Abnormal end thrust.

Dirt in bearings.

Solution

Remove and excess grease (see "Fan

Bearing Maintenance" [page AD-8] and

"Motor Maintenance" [page AD-9] for

lubrication instructions).

Replace the damaged wheel or driver.

Replace the motor.

Make sure all spacers and shims are in

good condition. Replace as necessary.

Clean and lubricate the bearings (see

"Fan Bearing Maintenance" [page AD-8]

and "Motor Maintenance" [page AD-9]

for lubrication instructions).

1 2 ... 90 91 92 93 94 95 96 97

Komentáře k této Příručce

Žádné komentáře